Click Here & Play a single, approx 3 minute video start to finish.... takes a little time to load but you'll see completely how the application of ceramic fluid is accomplished.  This video should only be played on faster communication type computers, because it just  takes to long to load ... the video file is approx. 60 Mbytes long for 3 minutes of movie.  It takes Win98SE 20 minutes to load.. the video works well with Microsoft Media Player.

  OR:    Short Snippets to see Below:

Each video takes about 10-15 seconds. Click one at a time to see short snippets of the video. Each video takes a little time to load and it is a Microsoft video program so thanks for your patience. After each video finishes then close the program to return here.

      Start intro to video    See the machine and 3 items of interest during the test, kg force gauge, amp meter and oil bath.

     Pinch tester uses a Timken bearing and race     

     Oil applied to be tested     Test applied to oil and a stall point is shown  on kg force gauge and amp gauge 5+amps.

     Pressure test to race and bearing   Shows the stall point a second time.

     Add Ceramic and mix the batch      Mix and apply the ceramic fluid in the oil bath.

     Finally run the ceramic with pinching and see  Finally test the Ceramic to see the friction reduction.

Return to Engine Treatment Program Home page          Return to top of this page

Information contained herein is deemed accurate and correct, but no warranty is implied or given. copyright (c) American CCF,  2003-2008 All rights reserved.
   Home | Contact us | Orders | Testimonials | MSDS | Tech 1 | Tech 2 | Emissions | Careers |